Specifications

36 AT-9800 Series Switch
C613-03059-00 REV E
Forcing a misaligned CAM will damage the CAM’s connector and CAM slot.
Press the CAM firmly into place. Secure the CAM to the support pillars
using the supplied screws.
The CAM is now ready to test.
Test ing CA M
To check that the switch has recognised the CAM, turn on the switch and enter
the command:
SHOW SWITCH
to display system information, including the amount of CAM installed (see
Figure 15 on page 36 and Figure 16 on page 37).
If there is no entry for the CAM, or the entry displays an unexpected value,
then the switch has not correctly detected the CAM’s presence. The most likely
cause is that the CAM is not correctly plugged into the CAM slot. Repeat the
installation process, paying particular attention to the CAM alignment and
insertion steps.
Use the SHOW SWITCH command again, and if the display is still not correct,
contact your authorised Allied Telesyn distributor or reseller.
Figure 15: Example output from the SHOW SWITCH command for a 9800 Series
switch with standard CAM (no external CAM).
Switch Configuration
------------------------------------------------------------
CAM size ( entries ) ....... 40960
Switch Address ............. 00-00-cd-05-01-0f
Learning ................... ON
Ageing Timer ............... ON
Number of Fixed Ports ...... 16
Number of Uplink Ports ..... 0
Mirroring .................. DISABLED
Mirror port ................ None
Ports mirroring on Rx ...... None
Ports mirroring on Tx ...... None
Ports mirroring on Both .... None
Number of WAN Interfaces ... 0
Name of Interface(s) ....... -
Ageingtime ................. 300
VLAN classification ........ To be defined
UpTime ..................... 00:00:03
Hashingfiled ............... L2 L3 L4
-----------------------------------------------------------