Specifications

12 AT-9800 Series Switch
C613-03059-00 REV E
• Stop bits: 1
• Flow control: Hardware
See “Using Windows Terminal and Windows Hyperterminal” on page 8
for more information on configuring emulation software.
Ensure that any power switches are in the On position and that the switch
is receiving power.
After the switch has booted, the log in prompt appears. If the log in prompt
doesn’t appear, press [Enter] two or three times.
When the switch boots for the first time it automatically creates an account
with manager privileges. The account has the log in name “manager” and
the password is “friend”.
At the log in prompt, enter the log in name and password.
Log in: manager
Password: friend
The switch’s command prompt appears and you can now configure the
switch using the command line interface.
Change the password as soon as possible. Leaving the manager account with
the default password is a serious security risk. Make sure that you remember
the new password as there is no way to retrieve it if it is lost.
Use the following command to change the account password:
set password
See the AT-9800 Series Software Reference for more information on
configuring the switch.
To access help
Before help is used for the first time, the help files must be defined.
To define the files, enter:
set help=help-filename
where help-filename is the name of a help file stored in flash.
To see a list of files stored in flash, enter:
show file
Help files have an HLP extension.
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.