Specifications

Hardware Reference 11
C613-03059-00 REV E
7. Save the current session. From the File menu, select:
•“Save”.
This creates a connection icon with the name you assigned in the
HyperTerminal group. To use the configuration:
• Double-click the connection icon in the HyperTerminal group.
When the HyperTerminal window appears, press:
• [Enter] a couple of times.
The switch’s log in prompt will appear.
Switch Start-up
This section outlines the log in and start-up procedures for your switch.
Although the switch will perform basic switching operations without being
configured, you will need to go through these log in and start-up procedures if
you wish to configure the switch and access its full layer 3 switching
capabilities.
To log In
To log in you must first connect the switch to a terminal or PC. This can be
done using the RS-232 Terminal Port (ASYN0). A ter-inal cable suitable for use
with ASYN0 is supplied with each switch.
Using the supplied terminal cable, or a cable you have made by following the
instructions in “Useful Cables” on page 16, connect your terminal or PC to
ASYN0.
Set the communication parameters on your terminal or terminal emulation
program to:
• Baud rate: 9600
• Data bits: 8
•Parity: None