User`s guide

AT-S45 User’s Guide

[M]odify Participation

This command is explained in the section Setting GVRP Status on

page 107

[A]dd VLAN Member

This command adds tagged ports to the VLAN. Type A and then

specify the ports that you want to add as tagged ports to the VLAN.

You can specify the ports individually (e.g., 2,3,5), as a range (e.g., 7-9),

or both (e.g., 2,5,7-9). Press Enter.

Note

To add untagged ports to the VLAN, perform Phase 2 on page 98.

[R]emove VLAN Member

This command removes tagged ports from the VLAN. Type R and

specify the tagged ports that you want to remove from the VLAN.

Press Enter. You can specify the ports individually (e.g., 2,3,5), as a

range (e.g., 7-9), or both (e.g., 2,5,7-9).

Note

You cannot use this command to remove untagged ports from a

VLAN. To remove untagged ports, perform Phase 2 below.

Furthermore, you cannot use this command to remove a port whose

GVRP participation has been set to Forbidden. You must first change

the port’s GVRP participation to Static, after which you can remove

the port from the VLAN.

Phase 2 You perform this phase whenever you need to add or remove an

untagged port from a VLAN. This phase explains how to change the

PVIDs of the ports so that they match the VID of a different VLAN. For

example, if you want to assign Port 2 as an untagged member of a VLAN

with a VID of 4, you must change the PVID of the port to 4.

1. From the Main Menu, type A to select the Advanced Switch

Configuration Menu.

2. From the Advanced Switch Configuration Menu, type V to select

VLAN Management.

3. Type S to select Set Port Config.