User`s guide

AT-S45 User’s Guide

Phase 2 This phase of creating a new VLAN converts the tagged ports that you

added to the new VLAN into untagged ports. This involves changing the

PVIDs of the ports so that they match the VID of the new VLAN. For

example, if you assigned the new VLAN a VID of 4, you must change the

PVIDs of the untagged ports to 4. The following procedure explains how

this is accomplished.

The following procedure assumes that you are continuing directly from

Phase 1.

1. From the VLAN Creation Menu, type Q to select Quit to Previous

Menu.

The VLAN Management Menu is displayed again.

2. Type S to select Set Port Config.

The VLAN Port Configuration Menu is displayed. An example is

shown in Figure 26.

Figure 27 VLAN Port Configuration Menu

This window lists the ports on the switch and each port’s current PVID

assignment. For example, referring to the figure above, Ports 1 to 8 all

have a PVID of 1, meaning that they are untagged members of the

Default VLAN, which has a VID of 1.

3. To set a PVID, type V to select the Set Port VID option.

AT-9410GB Local Management System

VLAN Management -> VLAN Port Configuration Menu

Port PVID

---- ----

1 1

2 1

3 1

4 1

5 1

6 1

7 1

8 1

-------------------------------- <COMMAND> -----------------------

[N]ext page Set Port [V]ID

[P]revious Page

[Q]uit to previous menu

Command> _

Enter the character in square brackets to select option