User`s guide

AT-S45 User’s Guide

Note

It is a good idea to check the VLAN Type field in the window to make

sure it is set to 802.1Q, which happens to be the default. You can

create tagged and untagged VLANs only when the switch is

operating in the 802.1Q mode. For instructions on how to change

the switch’s VLAN mode, see Setting the VLAN Type on page 109.

3. From the VLAN Management Menu, select C for Create VLAN.

The VLAN Creation Menu in Figure 30 is displayed.

Figure 26 VLAN Creation Menu

4. Type I to select Set VLAN ID/Index.

The following prompt is displayed:

Enter VLAN ID ->Enter VLAN ID >

5. Enter a V ID for the new VLAN. The VID can be between 2 and 4094.

Press Enter.

If this VLAN will be unique in your network, then its VID must also be

unique from all other VIDs in the network.

AT-9410GB Local Management System

Enter the character in square brackets to select option

Advanced Switch Configuration -> VLAN Creation Menu

VLAN Index :

VLAN Name :

Device Member

-------- -----------------------------------------------------

---------------------------- <COMMAND> -----------------------------

Set VLAN [I]D/[I]ndex [S]elect Port Member

Set VLAN [N]ame [A]pply

[Q]uit to previous menu

Command>