User`s guide

AT-S45 User’s Guide
78
Configuring a Bridge’s STP Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
STP on a bridge is disabled by default. If you enable STP, the bridge
provides default STP parameters that are adequate for most
networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type S to select
Spanning Tree Configuration Menu.
The Spanning Tree Configuration Menu is displayed.
Figure 23 Spanning Tree Configuration Menu
AT-9410GB Local Management System
Enter the character in square brackets to select option
Basic Switch Configuration -> Spanning Tree Configuration Menu
STP Status: Enabled
Root Port: 0
Root Path Cost: 0
Designated Root: 8000 0030AB000850 Bridge ID: 8000 0030AB000920
Hello Time: 2 Sec. Bridge Hello Time: 2 Sec.
Maximum Age: 20 Sec. Bridge Maximum Age: 20 Sec.
Forward Delay: 15 Sec. Bridge Forward Delay: 15 Sec.
---------------------------- <COMMAND> ------------------------------
Enable/Disable [S]TP Set Bridge Maximum [A]ge
Set Bridge Pr[i]ority Set Bridge Forward [D]elay
Set Bridge [H]ello Time Spanning Tree [P]ort Configuration
[Q]uit to previous menu
Command>