User`s guide

AT-S45 User’s Guide
66
Figure 20 Trunking Configuration Menu
3. Type A to select Add Trunk Member.
The following prompt is displayed.
Enter trunk group number>
Trunk group is in the range from 1 to 4
4. Enter the trunk group number to configure and press Return.
The following prompt is displayed.
Enter port members (up to 4 ports) for trunk 1>
Separate each port number with a comma;
Specify a range of ports by a hyphen
5. Enter the ports that will constitute the port trunk and press Return.
You can specify up to a maximum of 4 ports either individually
(e.g., 1,2,3,4) or as a range (e.g., 7-10).
6. To set trunk status, type S to display the status of the trunk.
The following prompt is displayed.
Enter trunk group number>
Trunk group is in the range from 1 to 4
7. Enter the trunk group number you want to set and press Return.
The following prompt is displayed.
Enable or Disable trunk group 1 (E/D)>
E for Enable; D for Disable
8. Type E to enable the new port trunk.
Figure 21 shows an example of the Port Trunking status window
with a port trunk.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Advanced Switch Configuration -> Trunk Configuration Menu
Group Status Port Members
----- -------- -------------------------------
1 Enabled 1, 2, 3, 4
2 Disabled
3 Disabled
4 Disabled
Note: The trunk port members must be within the same port group.
The port members of each port group are shown below.
----------------------- <COMMAND> ------------------------
[A]dd Trunk Member [S]et Trunk status
[R]emove Trunk Member [Q]uit to previous menu
Command>