User`s guide

AT-S45 User’s Guide
53
Configuring Port Parameters
To configure the parameter settings for a port on the switch, perform the
following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type P to select Port
Configuration.
The Port Configuration Menu in Figure 15 is displayed.
Figure 15 Port Configuration Window
3. Set the port parameters as desired. To set a parameter, type the letter
of the appropriate command. This toggles the parameter through its
possible settings. The commands are described below.
Set [S]tatus
You use this command to enable or disable a port. When disabled,
a port will not receive or transmit frames.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Basic Switch Configuration -> Port Configuration Menu
Port Trunk Type Link Status Mode Flow Ctrl
---- ----- ------ ----- ---------- ------- ---------
1 1 1000TX Down Enabled 1000-FDx Disabled
2 1 1000TX Down Enabled 1000-FDx Disabled
3 1 1000TX Down Enabled 1000-FDx Disabled
4 1 1000TX Down Enabled 1000-FDx Disabled
5 --- 1000TX Down Enabled Auto Enabled
6 --- 1000TX Down Enabled Auto Enabled
7 --- 1000TX Down Enabled Auto Enabled
8 --- 1000TX Down Enabled Auto Enabled
9 --- 1000TX Down Enabled Auto Enabled
10 --- 1000TX Down Enabled Auto Enabled
11 --- 1000X Down Enabled 1000-FDx Enabled
12 --- 1000X Down Enabled 1000-FDx Enabled
-------------------------- <COMMAND> ----------------------------
Set [S]tatus Set [F]low control
Set [M]ode [Q]uit to previous menu
Command>