User`s guide

AT-S45 User’s Guide
51
Displaying Port Status
To display the status of the ports on the switch, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type P to select Port
Configuration.
The Port Configuration Menu in Figure 14 is displayed.
Figure 14 Port Configuration Menu
The columns in the window are described below:
Port
The port number.
Trunk
The trunk group number. A number in this column indicates that
the port is a member of a port trunk.
Type
The maximum operating speed of the port.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Basic Switch Configuration -> Port Configuration Menu
Port Trunk Type Link Status Mode Flow Ctrl
---- ----- ------ ----- ---------- ------- ---------
1 --- 1000TX Down Enabled Auto Enabled
2 --- 1000TX Down Enabled Auto Enabled
3 --- 1000TX Down Enabled Auto Enabled
4 --- 1000TX Down Enabled Auto Enabled
5 --- 1000TX Down Enabled Auto Enabled
6 --- 1000TX Down Enabled Auto Enabled
7 --- 1000TX Down Enabled Auto Enabled
8 --- 1000TX Down Enabled Auto Enabled
9 --- 1000TX Down Enabled Auto Enabled
10 --- 1000TX Down Enabled Auto Enabled
11 --- 1000X Down Enabled 1000-FDx Enabled
12 --- 1000X Down Enabled 1000-FDx Enabled
-------------------------- <COMMAND> ----------------------------
Set [S]tatus Set [F]low control
Set [M]ode [Q]uit to previous menu
Command>