User`s guide

AT-S45 User’s Guide
38
Activating the AT-S45 Management Software Default Values
The procedure in this section returns all AT-S45 management
parameters to their default values. This procedure also deletes any
VLANs that you have created on the switch.
Note
The AT-S45 default values can be found in Appendix A, AT-S45
Default Settings on page 232.
To return the AT-S45 management software to its default settings,
perform the following procedure:
1. From the Main Menu, type T to select Switch Tools.
2. From the Switch Tools Configuration Menu, type R to select System
Reboot.
The System Reboot window in Figure 8 is displayed.
Figure 8 System Reboot Menu
3. From the System Reboot Menu, type O to select Set Reboot Option.
The following prompt is displayed:
Select reboot option (F/I/N)>
4. Select the desired reset option. The options are described below.
F - Factory Defaults
Resets the switch and returns all parameter settings to their
factory default values.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Main Menu -> System Reboot Menu
Reboot Status: Stop
Reboot Type: Normal
--------------------------- <COMMAND> -----------------------------
Set Reboot [O]ption
Start [R]eboot Process
[Q]uit to previous menu
Command>