User`s guide

AT-S45 User’s Guide

Configuring SNMP Community Strings and Trap IP Addresses

To configure the SNMP community strings for the switch and to assign

up to four IP addresses of management stations to receive traps from

the switch, perform the following procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

2. From the Basic Switch Configuration Menu, type N to select SNMP

Configuration.

The SNMP Configuration window in Figure 7 is displayed.

Figure 7 SNMP Configuration Menu

3. Adjust the parameters as desired. The commands for changing the

parameters are described below.

Set SNMP [R]ead Community

This command sets the SNMP community name. The maximum

length for a read community name is 20 characters.

Set SNMP [W]rite Community

This command sets the SNMP write community. The parameter

can be set to private or public.

AT-9410GB Local Management System

Enter the character in square brackets to select option

Basic Switch Configuration Menu -> SNMP Configuration Menu

SNMP Read Community: public

SNMP Write Community:private

Trap Authentication: Enable

SNMP Trap Receivers:

No. Status IP Address Community

-- ------- ---------------- ---------------------------

1 Enabled 145.35.19.1 Orion

2 Deleted <empty> <empty>

3 Deleted <empty> <empty>

4 Deleted <empty> <empty>

-------------------------- <COMMAND> ---------------------------

Set SNMP [R]ead Community [A]dd SNMP Trap Receiver

Set SNMP [W]rite Community [D]elete SNMP Trap Receiver

[M]odify SNMP Trap Receiver [E]nable/Disable

Authentication Trap

Enable/Disable SNMP [T]rap Receiver [Q]uit to previous menu

Command>