User`s guide

AT-S45 User’s Guide

The System IP Configuration Menu in Figure 4 is displayed.

Figure 4 System IP Configuration Menu

3. Change the parameters as desired.

The commands for changing the parameters are described below:

Set [I]P Address

This command specifies the IP address of the switch. You must

specify an IP address if you intend to remotely manage the switch

using a web browser, a Telnet utility, or an SNMP management

program.

Set Subnet [M]ask

This command specifies the subnet mask for the switch. You must

specify a subnet mask if you assigned an IP address to the switch.

Set Default [G]ateway

This command specifies the default router’s IP address. This

address is required if you intend to remotely manage the switch

from a management station that is separated from the switch by

a router.

AT-9410GB Local Management System

Enter the character in square brackets to select option

Basic Switch Configuration -> System IP Configuration Menu

MAC Address: 00:30:AB:00:09:20

IP Address: 149.35.19.168

Subnet Mask: 255.255.253.0

Default Gateway: 149.35.19.1

DHCP Mode: Disabled

------------------- <COMMAND> ------------------

Set [I]P Address

Set Subnet [M]ask

Set Default [G]ateway

Enable/Disable [D]HCP Mode

[Q]uit to previous menu

Command>