User`s guide

AT-S45 User’s Guide
30
Configuring an IP Address
The procedure in this section explains how to manually assign an IP
address, subnet mask, and gateway address to the switch from a local or
Telnet management session. (If you want the switch to obtain its IP
configuration from a DHCP server on your network, go to the procedure
Activating the DHCP Service on page 34.)
To manually set a switch’s IP address, perform the following procedure:
1. From the Main Menu, type B to select the Basic Switch Configuration
Menu.
The Basic Switch Configuration Menu in Figure 3 is displayed.
Figure 3 Basic Switch Configuration Menu
2. From the Basic Switch Configuration Menu, type I to select
System IP Configuration.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Main Menu -> Basic Switch Configuration Menu
System [A]dministration Configuration
System [I]P Configuration
S[N]MP Configuration
[P]ort Configuration
[U]ser Interface Configuration
[F]orwarding Database Menu...
[S]panning Tree Configuration
Storm [C]ontrol Configuration
[Q]uit to previous menu
Command>