User`s guide

28
Chapter 3
Basic Switch Parameters
This chapter contains a variety of information and procedures. There is a
discussion on when to assign an IP address to a switch and the different
ways that you can go about it. There are also procedures for resetting
the switch, activating the original switch default settings, and more.
Sections in the chapter include:
❑ When Does an AT-9410GB Switch Need an IP Address? on
page 29
❑ Configuring an IP Address on page 30
❑ Configuring System Administration Information on page 32
❑ Activating the DHCP Service on page 34
❑ Configuring SNMP Community Strings and Trap IP Addresses
on page 36
❑ Activating the AT-S45 Management Software Default Values
on page 38
❑ Resetting the Switch on page 40
❑ Configuring the AT-S45 Management Security Features on
page 41
❑ Viewing the AT-S45 Version Number and Switch MAC Address
on page 44
❑ Pinging a Network Device on page 45
❑ Bootstrap Configuration on page 47