User`s guide

AT-S45 User’s Guide

Starting a Local

Management

Session

To start a local management session, perform the following procedure:

1. Connect one end of the management cable included with the switch

to the RS232 Terminal Port on the unit.

Figure 1 Connecting a Terminal or PC to the RS232 Terminal Port

2. Connect the other end of the cable to an RS-232 port on a terminal or

PC with a terminal emulator program.

3. Configure the terminal or terminal emulator program as follows:

❑ Baud rate: 9600

❑ Data bits: 8

❑ Parity: None

❑ Stop bits: 1

❑ Flow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulator program.

4. Press the Return key twice.

5. When prompted for a user name and password, enter the user name

and password for the management software. The default for both is

“manager”. (The user name and password are case-sensitive.)

PWR

10/100Mbps

10GbE

ACT

FDX

RS232

AT-9410GB

12-Port Gigabit Managed Switch