User`s guide

AT-S45 User’s Guide
219
Configuring QoS
Note
Quality of Service is not supported in port-based VLAN mode.
To configure QoS, perform the following procedure:
1. From the Home page, select Advanced Config. and then select
Quality of Service from the sub-menu.
The management software displays the Quality of Service window
in Figure 84.
Figure 84 Quality of Service Window
1. Select a Low or High priority queue for the traffic classes whose
priority you wish to change.
Note
The default setting for traffic classes 0 - 3 is the low priority queue.
The default setting for traffic classes 4 - 7 is the high priority queue.
2. Select Enable from the QoS Status pull-down menu.
3. Click the Apply button.