User`s guide

AT-S45 User’s Guide
216
Adding Static MAC Addresses
The management software allows you to assign up to 254 static MAC
addresses per port on an AT-9410GB Gigabit Ethernet Switch.
To add a static address to the MAC address table, perform the following
procedure:
1. On the Home page, select the Basic Config menu tab and then select
the Forwarding DB tab from the sub-menu. Select Static FDB from
the next sub-menu.
The Static MAC Address Configuration window will appear, as
displayed.
Figure 82 Static MAC Address Configuration Window
2. Enter a MAC Address you want to configure in the MAC Address field.
3. Click on the Port Number pull-down menu and select the port
number you want to configure.
4. Enter a VLAN ID value in the VLAN ID field.
5. Click Apply.
The management software adds the static address to the MAC
address table for the specified port and VLAN.
6. Repeat steps 2 and 5 to enter additional static MAC addresses.