User`s guide

AT-S45 User’s Guide
209
Setting the VLAN Type
The AT-9410GB switch can operate in either the 802.1Q VLAN mode for
creating tagged and untagged VLANs or the port-based VLAN mode.
Note
The VLAN Type default is 802.1Q.
To change the switch’s VLAN Type, perform the following procedure:
1. Click on the Advanced Config menu tab and select VLAN Config
from the sub-menu. Select VLAN Info from the next sub-menu.
The VLAN Information page will appear.
2. Using the VLAN Support pull-down menu, select either 802.1Q to
create tagged and untagged ports or Port Based to create port-based
VLANs.
Note
The default is 802.1Q.
3. Click the Apply button.
Note
Changing the VLAN Type setting deletes all VLANs except the
Default VLAN.