User`s guide

AT-S45 User’s Guide
190
Configuring STP Port Settings
To display and configure the STP port settings, perform the following
procedure:
1. From the Home page, click on Basic Config., Spanning Tree and
then STP Port Config. from the sub-menu.
The Spanning Tree Port Configuration window in Figure 66 is
displayed.
Figure 66 Spanning Tree Port Configuration
2. Adjust the parameter settings as desired. The parameters are
described below.
The 9410GB Gigabit Ethernet Switch has the “All” setting that
allows a global setting to be set for all ports on the switch.
3. Click Apply.
Priority
This parameter is used as a tie breaker when two or more ports are
determined to have equal costs to the root bridge. The range is 0-
255. The default value for priority is 128.