User`s guide

AT-S45 User’s Guide
188
Configuring a Bridge’s STP Settings
Caution
STP on a bridge is disabled by default. If you enable STP, the bridge
provides default STP parameters that are adequate for most
networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
To configure a bridge’s STP parameters, perform the following
procedure:
1. From the Home page, click on Basic Config., Spanning Tree and
then STP Config. from the sub-menu.
The Spanning Tree Bridge Configuration window in Figure 65 is
displayed.
Figure 65 Spanning Tree Window - Configuration
2. Adjust the bridge STP settings as needed. The parameters are
described below.