User`s guide

AT-S45 User’s Guide

Local Management Session

You establish a local management session with an AT-9410GB Gigabit

Ethernet switch by connecting a terminal or a PC with a terminal

emulator program to the RS232 Terminal port on the front panel of the

switch, using the null-modem management cable include with the

switch. This type of management session is referred to as “local” because

you must be physically close to the switch, such as in the wiring closet

where the switch is located.

Once the session is started, you will see a menu from which you can

make selections to configure and monitor the switch. You can configure

all of a switch’s operating parameters from a local management session.

Note

For instructions on starting a local management session, refer to

Starting a Local Management Session on page 25.