User`s guide

AT-S45 User’s Guide
172
Type
This number specifies the maximum operating speed of the port.
Link Status
The link status between the port and the end node connected to
the port. Possible values are:
Up - indicates that a valid link exists between the port and the end
node.
Down - indicates that the port and the end node have not
established a valid link.
Admin. Status
The current operating status on the port. Possible values are:
Enabled - Indicates that the port is enabled.
Disabled - Indicates that the port is disabled.
Mode
The operating speed and duplex mode of the port. Possible
settings for this parameter are:
❑ Auto-Negotiate: The port will Auto-Negotiate both speed and
duplex mode. This is the default.
❑ 1000Mbps - Half Duplex
❑ 100Mbps - Full Duplex
❑ 10Mbps - Full Duplex
❑ 1000Mbps - Half Duplex
❑ 100Mbps - Half Duplex
❑ 10Mbps - Half Duplex
Flow Control
The flow control setting for the port. Possible values are:
Enabled - Flow control is activated on the port.
Disable - No flow control on the port.
3. Once you have made the desired changes, click Apply.
The switch immediately activates the parameter changes on the
port.