User`s guide

AT-S45 User’s Guide
171
Configuring Port Parameters
To configure the parameter settings for a port on a switch, perform the
following procedure:
1. From the Home page, select Basic Config. and then select
Port Config. from the sub-menu.
The Port Configuration window is shown in Figure 57.
Figure 57 Port Configuration window
2. Adjust the port parameter(s) that you want to configure. You can
configure only one port at a time.
The parameters are described below.
Port Index
This number specifies the number of the port of the switch. This
parameter can not be changed.
Trunk
This number specifies the number of the trunk that the port
resides in, if any. For instructions on how to create a port trunk,
refer to Port Trunks on page 182.