User`s guide

AT-S45 User’s Guide
162
Resetting a Switch
To reset a switch, perform the following procedure:
1. On the Home page, click on the Tools menu tab. The Tools sub-menu
will appear. Choose System Reboot from the sub-menu.
The System Reboot page in Figure 52 is displayed.
Figure 52 System Reboot
The options in the System Reboot page are defined below. Change
the options as desired.
Reboot Status
Sets the reboot status of the switch. This parameter can be set to Start or
Stop. The default setting is stop.
Reboot Type
Sets the reboot type of the switch. This parameter can be set to:
❑ Factory Defaults
Resets the switch and returns all parameter settings to their
factory default values.
❑ Factory Defaults Except IP
Resets the switch and returns all parameter settings, except for
the IP address, subnet mask, and gateway address, to their factory
default values.
❑ Normal Defaults
Resets the switch but retains all current parameter settings.
2. Select the desired reboot option from the Reboot Type field.
3. Select Start from the Reboot Status field.