User`s guide

AT-S45 User’s Guide
160
Configuring the SNMP Parameters and Trap IP Addresses
To change the switch’s SNMP community strings or to specify the IP
addresses of management stations to receive traps from the switch,
perform the following procedure:
1. From the Home page, select Basic Config. and then select
SNMP Config. from the sub-menu.
The SNMP Configuration page in Figure 51 is displayed.
Figure 51 SNMP Configuration
2. Adjust the parameters as desired. The parameters are described
below.
Enable Community
Disable Community
Delete Community
Use these parameters to set a switch’s SNMP community strings.
Trap Receiver 1
Trap Receiver 2
Trap Receiver 3