User`s guide

AT-S45 User’s Guide
153
System Subnet Mask
This parameter specifies the subnet mask for the switch. You must
specify a subnet mask if you assigned an IP address to the switch.
System Default Gateway
This parameter specifies the default router’s IP address. This
address is required if you intend to remotely manage the switch
from a management station that is separated from the switch by
a router.
DHCP Mode
This parameter specifies the DHCP mode of the switch. You can
enable or disable the DHCP mode. The default setting is set to
disabled. For background information on DHCP, refer to
Activating the DHCP Service on page 34.
3. After you have set the parameters, click Apply. Your changes are not
stored to flash in the switch until you select Apply.
4. If you made a change to the IP address, subnet mask, or gateway
address, you must reset the switch to activate your change. To reset a
switch from a web browser management session, refer to Resetting
a Switch on page 162.