User`s guide

AT-S45 User’s Guide
152
Configuring an IP Address
Note
For guidelines on when to assign an IP address, subnet address, and
gateway address to an AT-9410GB switch, refer to When Does an
AT-9410GB Switch Need an IP Address? on page 29.
To set the IP address on an AT-9410GB Gigabit Ethernet switch, perform
the following procedure:
1. From the Home Page, select Basic Config. and then select IP. Config.
from the sub-menu.
The IP Configuration menu in Figure 47 is displayed.
Figure 47 IP Configuration menu
2. Change the parameters as desired.
The parameters are described below:
System MAC Address
This parameter specifies the MAC address of the switch. This
parameter cannot be changed.
System IP address
This parameter specifies the IP address of the switch. You must
specify an IP address if you intend to remotely manage the switch
using a web browser, a Telnet utility, or an SNMP management
program.