User`s guide

AT-S45 User’s Guide
148
Starting a Web Browser Management Session
This section explains how to start a web browser management session.
Note
In order for you to manage an AT-9410GB switch using a web
browser, the switch must have an IP address. Initially assigning an IP
address to a switch can only be done through a local management
session. For instructions, refer to Configuring an IP Address on
page 30.
To start a web browser management session, perform the following
procedure:
1. Start your web browser.
Note
If your PC with the web browser is connected directly to the switch
to be managed or is on the same side of a firewall as the switch, you
must configure your browser’s network options not to use proxies.
Consult your web browser’s documentation on how to configure
the switch’s web browser not to use proxies.
2. Enter the IP address of the switch you want to manage in the URL field
of the browser, as shown in Figure 45.
Figure 45 Entering a Switch’s IP Address in the URL Field
3. When prompted, enter the user name and password. The default user
name and password is “manager” and both are case-sensitive.
On a web management session, the user name and password
cannot be changed. To change the user name and password, refer
to the local management procedure Configuring an IP Address
on page 152.
Switch’s IP Address