User`s guide

AT-S45 User’s Guide
140
Downloading New Management Software from a Local
Management Session
This section contains the procedure for downloading a new version of
AT-S45 management software onto a switch from a local management
session. The procedure takes approximately 12 minutes to complete.
Note
You cannot perform this procedure from a Telnet or web browser
management session.
Caution
The switch will not forward Ethernet traffic during the software
download and initialization process.
Note
The current configuration of the switch (e.g., IP address, subnet
mask, and virtual LANs) is maintained when you install a new
software image on the switch. To return a switch to its default
configuration, refer to Activating the AT-S45 Management
Software Default Values on page 38.
This procedure assumes that you have already obtained the new version
of management software and have stored it on the computer from
which you will be performing this procedure.
To download a new software onto an AT-9410GB switch, perform the
following procedure:
1. Establish a local management session on the switch where you intend
to download the new management software.
For instructions, refer to Starting a Local Management Session
on page 25.
2. From the Main Menu, type T to select Switch Tools Configuration
Menu.
3. From the Switch Tools Configuration menu, type U to select Software
Upgrade Menu.
4. From the Software Upgrade menu, type X for XModem Software
Upgrade.