User`s guide

AT-S45 User’s Guide
123
Configuring QoS
To configure QoS for the switch, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
2. From the Advanced Switch Configuration Menu, type S to select
Quality of Service Configuration Menu.
The Quality of Service Configuration Menu is displayed.
Figure 34 Quality of Service Configuration Menu
3. From the Quality of Service Configuration Menu, type S to select Set
Status.
The following prompt is displayed.
Enable or Disable QoS (E/D) >
E for Enable; D for Disable
4. Type E to enable the service or D to disable it. The default setting is
disabled.
AT-9410GB Local Management System
Enter the character in square brackets to select option
Advanced Switch Configuration -> Quality of Service Configuration Menu
QoS Status : Disabled
Traffic Class Queue
------------- -------------
0 1
1 1
2 1
3 1
4 0
5 0
6 0 0 : Highest
7 0 1 : Lowest
---------------------------- <COMMAND> ------------------------------
Set [S]tatus
Set [P]riority Queue
[Q]uit to previous menu
Command>