User`s guide

AT-S45 User’s Guide
118
Adding Static MAC Addresses
The management software allows you to assign up to 255 static MAC
addresses per port on an AT-9410GB Gigabit Ethernet Switch.
To add a static address to the MAC address table, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type F to select
Forwarding Database Menu.
3. From the Forwarding Database menu, type S to select Static Address
Table Menu.
4. From the Static Address Table Menu, type A to Add New Entry.
The following prompt is displayed:
Enter MAC Address(xx:xx:xx:xx:xx:xx) >
5. Enter the static MAC address in the following format:
xx:xx:xx:xx:xx:xx
Once you have specified the MAC address, the following prompt
is displayed:
Add new entry->Enter port number >
Port number is in range of 1 to 12
6. Enter the port number where the static address is to be assigned.
Once you have specified the port number, the following prompt
is displayed:
Add new entry->Enter VLAN ID>
VLAN ID is in range of 1 to 4094
7. Enter the VID of the VLAN where the port is a member.
Once you have specified the VLAN ID, the management software
adds the static address to the MAC address table.
8. Repeat steps 4 to 7 to enter additional static MAC addresses.