User`s guide

AT-S45 User’s Guide
106
5. To modify the VLAN, use the commands at the bottom of the screen.
The commands are described below:
[C]hange a VLAN Name
This command changes a VLAN’s name. Type C and enter the new
name at the command prompt.
[M]odify Participation
This command is disabled when the switch is operating in the port-
based VLAN mode.
[A]dd VLAN Member
This command adds ports to the VLAN. Type A and then specify the
ports that you want to add as members of the VLAN. You can specify
the ports individually (e.g., 2,3,5), as a range (e.g., 7-9), or both (e.g.,
2,5,7-9). Press Enter.
Note
Any port that you add to a VLAN remains a member of the VLAN(s)
in which it is currently assigned. If you do not want the port to be a
shared port, you must remove it from the other VLANs.
[R]emove VLAN Member
This command removes ports from the VLAN. Type R and specify the
tagged ports that you want to remove from the VLAN. Press Enter.
You can specify the ports individually (e.g., 2,3,5), as a range (e.g., 7-9),
or both (e.g., 2,5,7-9).
Note
You cannot remove a port if it is not already a member of another
VLAN.