User`s guide

AT-S45 User’s Guide
103
Creating a Port-based VLAN
To create a new port-based VLAN, perform the following procedure:
Note
This procedure assumes that the switch is already running in the
Port-based VLAN mode. For instructions on how to change the
VLAN mode of the switch, refer to Setting the VLAN Type on page
109.
1. From the Main Menu, type A to select Advanced Switch Configuration
Menu.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
The VLAN Management Menu is displayed.
3. From the VLAN Management Menu, type C to select Create VLAN.
The VLAN Creation Menu in Figure 30 is displayed.
Figure 30 VLAN Creation Menu
4. Type I to select Set VLAN ID/Index.
The following prompt is displayed:
Enter VLAN ID ->Enter VLAN ID >
AT-9410GB Local Management System
Advanced Switch Configuration -> VLAN Creation Menu
VLAN Index :
VLAN Name :
Port Member
------------------------------------------------------
---------------------------- <COMMAND> -----------------------------
Set VLAN [I]D/[I]ndex [S]elect Port Member
Set VLAN [N]ame [A]pply
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option