Install guide

10
AT-S26 Software Default Setting
Table 4 lists the default settings for the AT-S26 software that comes pre-
installed on the Ethernet switch.
Table 4
Ethernet Switch Default Settings
Settings Default
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway Address 0.0.0.0
Get Community String public
Set Community String private
Trap Community String public
Spanning Tree Protocol Disabled
Bridge Priority 32768
Bridge Max Age Time 20
Bridge Hello Time 2
Bridge Forwarding Delay 15
Telnet Access Enabled
System Name None
Omega Password No password assigned
Omega Time-out Value 5 minutes
Download Password ATS26
Duplex Mode 10/100Base-TX Ports Auto-negotiating
Duplex Mode 100Base-FX Ports Full-duplex
Duplex Mode 1000Base-SX Ports Full-duplex
Active Aging Time (MAC Address Table) 300 seconds
High Port Speed Auto-negotiating
Domain Name None
VLAN Name Default VLAN (all ports)
PVID/VID 1