User`s guide

AlliedWare Plus Version 2.1.1 Software Release Notes
PN 613-001353 Rev A 7 Allied Telesis, Inc.
Note:
If your TFTP server is case sensitive, be sure to use upper and lowercase characters in the
filename.
After receiving the file from the TFTP server, the switch writes it to flash memory. The entire
process takes several minutes. The process is finished when the switch displays the
Privileged Executive mode prompt again.
4. From the Privileged Executive mode, enter the SYSTEM REBOOT command.
(none)# system reboot
5. Wait for the switch to complete the reset process and then start a new local or remote
management session.
6. From the Privileged Executive mode, enter the SHOW VERSION command:
(none)# show version
7. Verify that the values in the Application Version, Application BuildTime and Application
BuildDate fields are the same as those shown in step 2 in Phase 4.
8. Enter the SHOW IP INTERFACE BRIEF command to verify that the switch still has its IP
address:
(none)# show ip interface brief
If the switch has lost its IP address, repeat Phase 2. If the switch retained its IP address,
perform Phase 6.
Phase 6: Installing AlliedWare Plus Version 2.1.1
1. Start the TFTP server on your network.
2. If you have not already started a local or remote management session on the switch, do so
now.
3. From the Privileged Executive mode, use the hidden APPDOWNLOAD command to
download the new AlliedWare Plus v2.1.1 Management Software to the switch. The
command has this format:
appdownload ipaddress filename .img
The IPADDRESS parameter is the IP address of the TFTP server on your network and the
FILENAME parameter is the filename of the AlliedWare Plus Management Software on your
TFTP server. The extension must be “.img”.
In this example of the command, the IP address of the TFTP server is 149.214.21.17 and the
filename is ats-9000-2.1.1.img
(none)# appdownload 149.214.21.17 ats-9000-2.1.1.img
After receiving the file from the TFTP server, the switch writes it to flash memory. The entire
process takes several minutes. The switch displays this message when the process is
finished:
DOWNLOAD COMPLETE! Please restart the unit.
Note:
Do not reset the switch yet. Instead, continue with the next step to delete all the existing AT-S100
configuration files from the file system. The commands in those files are not compatible with
AlliedWare Plus. If you prefer to retain the files, skip steps 4 and 5 and go to step 6 to reset the
switch.