User`s guide

AlliedWare Plus Version 2.1.1 Software Release Notes
PN 613-001353 Rev A 2 Allied Telesis, Inc.
Note:
AT-9000 Switches manufactured after May 2010 come with AlliedWare Plus Management
Software pre-installed. Units manufactured before that date have AT-S100 Management
Software.
This version supports the following SFP modules:
 AT-SPTX (Supported only at 1G.)
 AT-SPEX
 AT-SPSX
 AT-SPFX/2
 AT-SPFX/15
 AT-SPLX10
 AT-SPLX40
 AT-SPZX/80
 AT-SPBD10-13
 AT-SPBD10-14
 AT-SPFXBD-LC-13
 AT-SPFXBD-LC-15
Upgrading the AT-9000 Switch to AlliedWare Plus from AT-S100 Management Software
This is the upgrade procedure for the AT-9000 Switch. It explains how to replace the AT-S100
Management Software with the AlliedWare Plus Version 2.1.1 Management Software. Here are
the requirements:
 A terminal or a computer with a terminal emulator program.
 The management cable that comes with the switch.
 A TFTP server on your network.
 AT-S100 Version 1.0.5 Patch 1 Management Software
 AlliedWare Plus Version 2.1.1 Management Software
The AT-S100 Version 1.0.5 Patch 1 and AlliedWare Plus Version 2.1.1 Management Software
programs are available from the Allied Telesis Restricted Software web site. The instructions in
Phase 1 explain how to obtain the software. If you do not have a TFTP server on your network,
you can download a free server from the Restricted Software web site or from this site:
 ftp://ftp.alliedtelesis.com/pub/utilities/at-tftpd.exe
Caution:
DO NOT PERFORM THE UPGRADE PROCEDURE ON A SWITCH THAT IS CONNECTED TO
A LIVE NETWORK UNTIL YOU HAVE READ THE FOLLOWING INFORMATION:
 The upgrade procedure resets the switch, disrupting network operations.
 The switch does not retain its current AT-S100 configuration after it is upgraded to AlliedWare
Plus. All parameters are returned to their default values. To restore the previous
configuration, you have to use the AlliedWare Plus commands.