User`s guide

AlliedWare Plus Version 2.1.1 Software Release Notes
PN 613-001353 Rev A 18 Allied Telesis, Inc.
Operational Notes
 The speed on an AT-SPFX/2 or AT-SPFX/15 module has to be manually set to 100Mbps with
the SPEED command. This example of the command configures the speed of an AT-SPFX/2
or AT-SPFX/15 module in slot 1 of an AT-9000/28SP Switch:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# speed 100
 If you want to assign an IPv6 management address to the switch, you must assign it
manually using the IPV6 IPADDRESS command. The switch cannot obtain an IPv6 address
with stateless autoconfiguration or from a DHCP6 server.
 You cannot use the web browser interface to configure these features:
— Access control lists
— Enhanced stacking
— Quality of Service
—SNMP
— Voice VLANs
Use the command line interface to configure the features.
 The web browser interface has been tested and found to be compatible with the following
web browsers:
— Microsoft Internet Explorer 7 and 8
— Mozilla Firefox 3.6.3
— Apple Safari 4.0.5
Note:
If you use the Explorer 8 web browser and the pull-down menus in the switch’s web browser
interface do not work, open the Internet Options window in the web browser, select the Security
tab, and set the custom settings to medium-high. Then refresh your page.
TACACS+ client Yes -
Secure (HTTPS) and non-secure (HTTP) web
browser interface
Yes Yes
TFTP client and IPv4 addresses Yes Yes
TFTP client and IPv6 addresses Yes -
Xmodem client - Yes
Zmodem client Yes -
Feature AlliedWare Plus
Management
Software
AT-S100
Management
Software