Specifications

36 AT-8900 Series Switch
C613-03075-00 REV A
After repeating the installation, use the SHOW SYSTEM command again, and
if the display is still not correct, contact your authorised Allied Telesyn
distributor or reseller.
If you have any difficulty with the DIMM at any time, contact your authorised Allied
Telesyn distributor or reseller and quote the serial numbers of both the base card on the
switch and the DIMM. The switch’s serial numbers and revision details can be read
using the SHOW SYSTEM command. It’s a good idea to record this information for
later reference.
Figure 15: Example output from the SHOW SYSTEM command for an AT-9800 Series switch, showing DRAM.
Diagnostics
The switch software includes a set of diagnostic programs. These programs
perform basic level checks of all system components. They do not run in
conjunction with the normal operating code, and require that the system be
Switch System Status Time 11:53:52 Date 08-Oct-2003.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------------
Base 201 AT-8948 P3-1 58366529
--------------------------------------------------------------------------------
Memory - DRAM : 65536 kB FLASH : 15360 kB
--------------------------------------------------------------------------------
SysDescription
Allied Telesyn AT-8948 version 2.6.1-00 20-Aug-2003
SysContact
SysLocation
SysName
SysDistName
SysUpTime
124284 ( 00:20:42 )
Boot Image : at8948bt.fbr size 618504 25-Aug-2003
Software Version: 2.6.1-00 20-Aug-2003
Release Version : 2.6.1-00 20-Aug-2003
Release built : Oct 7 2003 at 10:19:06
Patch Installed : NONE
Territory : usa
Help File : help.hlp
Main PSU : On Main Fan : On
RPS Monitor : Off
Current Temperature : 29 C
Configuration
Boot configuration file: snoopy.cfg (exists)
Current configuration: snoopy.cfg
Security Mode : Disabled
Warning (2048284): No patches found.