Specifications
Table Of Contents
- AT-8900 Series Hardware Reference
- Contents
- Models Covered By This Reference
- Why You Should Read This Reference
- Where To Find More Information
- Hardware Description
- Online Documentation
- AT-TFTP Server
- Using Windows Terminal and Windows Hyperterminal
- Switch Start-up
- RS-232 Terminal Port (ASYN0)
- Useful Cables
- Test Facility
- Power Supply Units (PSUs)
- Port, Connector, and Cable Combinations
- Troubleshooting
- Expansion Options
- Restricted Procedures
- Contacting Us
34 AT-8900 Series Switch
C613-03075-00 REV A
Figure 13: AT-8900 Series DIMM slot.
7. Align and insert the DIMM.
Holding a DIMM at an angle of about 30 degrees from horizontal, align the
notches on its connector strips with the notches on an empty DIMM slot
(see Figure 14 on page 35).
Insert the DIMM into the DIMM slot, sliding it along the two DIMM
guides until the retaining latches automatically click into place. The latches
should hold the DIMM firmly in place.
10/100Base-T ports
SFP sockets
DIMM
8948PCB