Specifications

Features in 291-08 95
Version 291-18
C613-10488-00 REV Q
CR00016578 IPv6 3 If IPv6 was disabled and a user entered any of the following commands:
add ipv6 interface
add ipv6 6to4
add ipv6 tunnel
create ipv6 interface
enable ipv6 advertising
then the router or switch correctly displayed a warning message to indicate
that IPv6 was disabled and also correctly performed the specified
configuration. However, it did not display an “Operation successful”
message to indicate that the configuration had changed.
This issue has been resolved. The router or switch now displays the
“Operation successful” message as well as the warning message.
YYYYYY- - YYY
CR00016735 ATM 3 Sometimes, the router displayed the following error message:
Internal Error: speed mismatch causing transmit internal rate underrun
error.
This was due to a mismatch in the synchronisation between the internal
rate of the ATM controller in the CPU and the speed of the ATM PHY
connector. This synchronisation mismatch had a small impact on ATM
performance. This issue has been resolved.
Y----------
CR00016925 TTY 3 If a user was accessing the router or switch via telnet, and sent a ^P (break)
character followed by the character d or D, then the router or switch
displayed an unwanted diagnostic message. This issue has been resolved.
YYYYYYYYYYY
CR00017019 Port
Authentication
3 On termination of an 802.1x session, an accounting message is sent to the
Radius server. This enhancement implements the Acct-Input-Octets,
Acct-Output-Octets, Acct-Input-Packets, and Acct-Output-Packets fields in
the message.
Note that this enhancement only applies to ports in single-supplicant mode.
These fields in the accounting message for ports in multi-supplicant mode
still all have a value of 0.
YYYYYYYYYYY
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800