Specifications

Features in 291-08 91
Version 291-18
C613-10488-00 REV Q
CR00011824 Firewall 3 When a firewall UDP session starts up, the session timeout should be 5
minutes for the first 5 packets of the session, then change to the configured
UDP session timeout value. Previously, the timeout changed after the 6th
UDP packet belonging to that session, instead of after the 5th packet.
This issue has been resolved.
YYYYYY- - - - Y
CR00012066 IP Gateway 3 The command show ip cassi command is obsolete but was still available.
This issue has been resolved. The command has been removed from the
command line. To obtain the same information, use the command show
conf dyn=ip.
YYYYYYYYYYY
CR00012168 Classifier 3 Output of the show classifier command displayed only the hexadecimal
protocol value for IP SNAP, instead of also displaying the protocol name.
This issue has been resolved. The output now displays:
0000000800 (IP SNAP)
YYYYYYYYYYY
CR00012885 OSPF, GUI 3 If there were virtual OSPF interfaces, then the OSPF Interfaces GUI page
showed all interfaces as belonging to the backbone area (0.0.0.0).
This issue has been resolved.
YYYY- YYY- YY
CR00013352 STP 3 The help displayed by the command set stp port=all ? listed some
parameters twice.
This issue has been resolved.
- - - YYYYYYYY
CR00013494 IP Gateway 3 Once a default local IP address had been set, it could not be deleted. This
was because the default interface does not have an interface number, but
to delete a local interface, the user must specify the interface’s number.
This issue has been resolved, by adding an option called default to the
delete ip local command. To delete the default local interface’s address,
use the command:
delete ip local=default
Note that this resets the interface, including removing its IP address, but
does not remove the interface itself.
YYYYYYYYYYY
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800