Specifications

Features in 291-08 83
Version 291-18
C613-10488-00 REV Q
CR00017488 Firewall 2 When a VoIP call using SIP was initiated from the public side of the firewall,
occasionally the firewall created two UDP sessions for the call with different
UDP source ports. This happened if the first packets of the STP (voice data)
stream arrived earlier than the 200 OK message that was supposed to
establish the session. The result was that the public side caller could not
hear the call.
This issue has been resolved.
YYYYYY- - - - Y
CR00017518 ISAKMP 2 The router or switch sometimes could not establish a VPN when the remote
peer was behind a NAT gateway and the router or switch’s remote ID was
set to default.
This issue has been resolved.
YYYYYY- - - - -
CR00017634 PPP 2 If a PPPoE AC service had been added, but AC mode had not been enabled
by using the enable ppp ac command, PADI frames were processed
anyway, potentially leading to a reboot.
This issue has been resolved.
YYYYYY- - YYY
CR00017659 TTY 2 Previously, it was not possible to configure a TTY service on the router (by
using commands like create service).
This issue has been resolved.
Y-Y--------
CR00017662 Core 2 Stopping and restarting two fans on the switch in a particular order could
put the fan fault detection mechanism into a state in which the system LED
would not flash for a fan fault.
This issue has been resolved.
----Y------
CR00017724 IGMP 2 When the switch had a hardware filter configured that would match and
discard a received IGMP packet, IGMP snooping still processed the packet
and added the details to its snooping database.
This issue has been resolved.
---YYYYY---
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800