Specifications

Features in 291-08 76
Version 291-18
C613-10488-00 REV Q
CR00013597 DVMRP,
Frame Relay
2 If a frame relay interface was configured as a DVMRP interface, then the
DLC value was not correctly generated in output of the command show
config dynam or in the configuration script generated by the command
create config.
This issue has been resolved.
YYYYY- - - - - -
CR00013660 Core, SNMP 2 Previously, SNMP returned an incorrect product ID number for AR750S-DP
routers.
This issue has been resolved. The value of the sysObjectID object is now 80
for AR750S-DP routers.
--Y--------
CR00013735 LACP,
Switching
2 When moving ports from an LACP-controlled trunk to a manually-
configured trunk, ports were incorrectly set in an STP blocking state.
Therefore, traffic would not flow over the trunk.
This issue has been resolved.
Note: When you move ports from an LACP-controlled trunk to a manually-
configured trunk, you must delete the ports from LACP.
--------YY-
CR00013763 OSPF 2 If the obsolete command set ospf rip=both was entered, the router or
switch correctly automatically replaced it with the following two
commands in the dynamic configuration:
add ospf redistribute protcol=rip
set ospf rip=export
However, if the command create config was used to save the
configuration, after system start-up the configuration file did not contain
the command add ospf redistribute protocol=rip. This meant that OSPF
stopped redistributing RIP routes after a reboot.
This issue has been resolved.
YYYYYYYYYYY
CR00013778 IPv6 2 If a user shortened the prefix length of an IPv6 interface address, then
lengthened it, it became impossible to change the prefix length again.
This issue has been resolved.
YYYYYY- - YYY
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800