Specifications

Features in 291-11 51
Version 291-18
C613-10488-00 REV Q
CR00008888 SYN 2 If a link-up SYN interface was disabled and then enabled again, or if the PPP
link over that interface was reset, then the ifOperStatus would change to
down and would not come back up again.
This issue has been resolved.
YYYYY––––––
CR00010428 Switch 2 If 0.0.0.0 was specified as an IP address for a VLAN interface, the incorrect
VLAN ID was written into the hardware routing table.
This issue has been resolved.
––––––––––Y
CR00013548 EPSR 2 Previously, if EPSR failed over, and some of the ports in the EPSR ring were
trunked, and there were ARPs present on the non-master port, the ARPs
would not be deleted. This meant that connectivity could be lost when the
ring switched back.
This issue has been resolved.
––––––––YY–
CR00016205 Firewall 2 The firewall did not allow any incoming traffic destined for a non-policy
interface, including the local interface.
This issue has been resolved. The firewall now allows traffic that comes
from a private trusted interface and is destined for a local interface.
YYYYYY––– –Y
CR00016331 Eth 2 With some link partners, an AR750S Ethernet port would stop receiving
packets after some hours or days, and a link state cycle or interface reset
was required to restore operation.
This issue has been resolved.
––Y––––––––
CR00017519 VLAN 2 ARP packets were not processed if they had been tagged with an 802.1p
priority value.
This issue has been resolved.
–––YYYYYYY–
CR00017540 Switch,
Classifier
2 On AT-8948 and AT-9900 series switches, if a classifier matched on VLAN
ID or interface, the switch did not correctly classify traffic.
This stopped hardware filters or QoS policies from working if they used
such classifiers.
This issue has been resolved.
––––––––YY–
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800