Specifications

Features in 291-13 40
Version 291-18
C613-10488-00 REV Q
Level 3
CR Module Level Description
AR44x / AR450 AR7x5 AR750S / AR770S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL AT-8948 / x900-48 AT-9900 AT-9800
CR00010538 Firewall 3 When firewall events were recorded in the Notify queue (displayed in
output of the command show firewall event=notify), the IP address
shown would be the address of the very first packet that belonged to that
event flow. For example, if 64 host scan packets were required to trigger a
host scan event and the first packet had a target IP of 1.1.1.1 and the 64th
had an IP of 1.1.1.64, then the IP address recorded would be 1.1.1.1, even
though the event was not actually recorded until the 64th packet arrived.
Additionally, the source and destination ports in this display would always
show as 0.
These issues have been resolved.The IP addresses shown are now those of
the particular packet that triggered the event notification, and the source
and destination ports match the actual ports used by that packet.
These issues were partially resolved in an earlier version—this version
contains an improved resolution.
YYYYYY––– –Y
CR00019207 Switching 3 A small number of x900-48 series switches were experiencing link problems
for some ports with some SFPs.
This issue has been resolved.
––––––––Y––
CR00020023 RSTP, SNMP 3 If the STP state of a switch port in a Rapid Spanning Tree was monitored via
SNMP using the BRIDGE-MIB, the value reported for a port in the Alternate
role was Listening when it should have been Blocking. Similarly, Blocking
was reported for a port in the Disabled role when it should have been
Disabled.
This issue has been resolved.
–––YYYYYYYY