Specifications

Features in 291-15 29
Version 291-18
C613-10488-00 REV Q
Level 3
CR Module Level Description
AR44x / AR450 AR7x5 AR750S / AR770S Rapier i Rapier w AT-8800 AT-8600 AT-8700XL AT-8948 / x900-48 AT-9900 AT-9800
CR00020551 DHCP 3 Previously, when an AT-8600 series switch was acting as a DHCP server with
a range defined, frequent Flash memory compactions would occur. This
issue has been resolved.
––––––Y––––
CR00020710 Switching 3 The show switch fdb port=<number> command was displaying FDB
information on incorrect ports.
This issue has been resolved. Also, if the show switch fdb
port=<number> command is run where the port specified is in a trunk, all
FDB entries for that trunk will be displayed, irrespective of which actual port
the source MAC ingressed.
––––––––YY–
CR00020794 Switching 3 If a user set a description on an AT-9924 switch port and then used the
command show int counter or show int=<id> to display interface
counters, the command output would include counters called ifInDiscards
and ifOutDiscards. However, these counters do not apply to these switches.
This issue has been resolved, so these counters no longer display.
–––––––––Y–
CR00020795 Switching 3 Previously, conditions existed where it was possible to remove a GBIC from
a AT-8800 or AT-8600 series switch, but have the GBIC LED stay on. This
could occur if a GBIC had been inserted into the switch in such a way that
the GBIC pins did not all make electrical connection at the same time.
This issue has been resolved. Removing a GBIC now always results in the
LED being turned off.
–––––YY––––
CR00021265 IP gateway 3 If the traceroute command was used from a Windows-based device to
trace the path to a destination through a switch which had two potential
return paths, then the traceroute command did not always produce the
correct results. This issue has been resolved.
YYYYYYYYYYY