Specifications

Enabling and installing this version 2
Version 291-18
C613-10488-00 REV Q
Enabling and installing this version
To use this maintenance version you must have a base release license for Software Release 2.9.1. Contact your distributor or reseller for more information about
licences. To enable this version and install it as the preferred version, use the commands:
enable rel=xx291-18.rez num=2.9.1
set install=pref rel=xx291-18.rez
where xx is the prefix to the filename, as shown in the table on page 1. For example, to install the version on an x900-48FE switch, use the commands:
enable rel=89291-18.rez num=2.9.1
set install=pref rel=89291-18.rez
Levels
Some of the issues addressed in this maintenance version include a level number. This number reflects the importance of the issue that has been resolved. The
levels are:
Level 1 This issue will cause significant interruption to network services, and there is no work-around.
Level 2 This issue will cause interruption to network service, however there is a work-around.
Level 3 This issue will seldom appear, and will cause minor inconvenience.
Level 4 This issue represents a cosmetic change and does not affect network operation.