Specifications

Features in 291-04 141
Version 291-18
C613-10488-00 REV Q
CR00013112 IP Gateway 4 The blackhole parameter of the commands add and set ip route had no “?”
help description.
This issue has been resolved.
–––––––YY–
CR00013188 LACP 4 Previously, when an attempt to add a port to LACP was unsuccessful, the switch
displayed an appropriate warning message followed incorrectly by an “operation
successful” message.
This issue has been resolved. The switch no longer displays “operation
successful” when port addition fails.
–––YYYYYY–
CR00013221 IP Gateway 4 The output of the command show ip route did not contain any spaces between
the route tag value and the metric value when the tag value was long.
This issue has been resolved by adding the missing spaces. The content and
relative position of the values have not changed.
YYYYYYYYYY
CR00013260 TACPLUS 4 If a user added a TACACS+ server when TACACS+ was not enabled, previously
the router or switch displayed a single “info” message that indicated that the
module was not enabled, but did not display a message confirming the server
addition. However, the router or switch did add the server.
This issue has been resolved. TACACS+ is now consistent with other modules—
the router or switch displays the following “warning” and “info” messages:
Warning (2111049): The TACP module is not enabled.
Info (1111003): Operation successful.
YYYYYYYYYY
CR00013463 Ping 4 Previously, if you used the ? or Tab keys to obtain help about the timeout
parameter for the ping command, the resulting help said that the maximum
timeout was 65535. However, the correct maximum is 60 seconds.
This issue has been resolved. The “?” help now displays the correct range of
values.
YYYYYYYYYY
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800