Specifications

Features in 291-05 114
Version 291-18
C613-10488-00 REV Q
CR00011629 PIM, PIM6,
ECMP
3 Previously, the switch’s count of PIM4 and PIM6 bad Bootstrap Messages (BSMs)
could be high, because the switch forwarded BSMs over interfaces that
contained an Equal Cost Multipath (ECMP) route to the receiving interface.
This issue has been resolved. BSMs are no longer forwarded via all interfaces
contained in an ECMP group, but only via one interface in the group.
-------YY-
CR00012495 IGMP 3 When an IGMP filter was destroyed, switch ports that used the filter did not have
their IGMP filter setting returned to “None”.
This issue has been resolved.
YYYYYYYYYY
CR00014324 PPP 3 The interface MIB ifInOctets and ifOutOctets counters displayed by the show
ppp counter command incorrectly included the lower layer framing octets and
were 5 octets per frame greater than they should have been.
This issue has been resolved.
YYYYY- - YYY
CR00014919 QoS,
DHCP
snooping
3 DHCP snooping accepted a minimum of one new client per QoS flow group,
instead of a minimum of one new client per port. This meant that DHCP
snooping sometimes did not respect the lease limit (maxlease) on a port.
This issue has been resolved.
- - - YYYYYY-
CR00015092 ATM 3 Previously, the information output by the “?” help for the ATM channel pcr
parameter was incorrect.
This issue has been resolved. The “?” help now displays:
required - decimal in the range 32-155000 (dependant on physical interface)
If you enter a value larger than the maximum PCR allowed on a specific physical
interface, the router now displays the following message for ADSL:
The PCR supplied was too large, the maximum is 1024
and the following message for SHDSL:
The PCR supplied was too large, the maximum is 4608
Y---------
CR Module Level Description
AR400 AR7x5 AR7x0S Rapier i AT-8800 AT-8600 AT-8700XL x900-48 AT- 9900 AT-9800